Q: What happens if somebody tries to “pop” a ScAir Structure with a sharp object?

A: ScAir Structures are manufactured with different technology than a balloon or rubber raft. The flow of air that inflates a ScAir Structures is constant and they are designed to “breath” air at all times. You can actually hear and feel air seeping out of the seams throughout the entire unit. If someone were to puncture a ScAir Structure, it would simply “bleed” air out of that opening and the area around the puncture would become soft and spongy. Holes can be patched temporarily with duct or gaffers tape and then sealed permanently, using the maintenance kits provided with your ScAir Structure.

Q: What if there is a power failure?

A: The ScAir Structure will not collapse immediately in the event of a power failure. The unit will become soft and will start to sink. You will have an opportunity to escort your patrons out through the exits, then re-establish power to the blowers.

Q: How many blowers does it take to inflate a ScAir Structure?

A: Only one for the ScAir Chambers and two for the ScAir Haunts.

Q: How much electricity do ScAir Structures use?

A: The inflation blowers require approximately 11 amps while they are running. We suggest using a dedicated 15 amp circuit for each blower.

Q: What Safety Features are built into ScAir Structures?

A: ScAir Structures are built from flame resistant material. The entrances and aisles are wheelchair accessible. There are four exits (one on each side) and ventilation hatches built into the ceiling.

Q: How is the ScAir Structure assembled?

A: The ScAir Haunt assembles in hours by inflating the grids on top of the floor, then deflating it to attach the roof. At this point the interior walls are attached and the unit will be ready for your decorations. The ScAir Chambers can be assembled in minutes. Simply roll out and unfold the unit, attach the blower and inflate. That’s it!

Q: What is it like inside a ScAir Structure?

A: The inside of a ScAir Haunt represents a grid pattern of inflated columns 3’ apart. You can design hallways with the provided walls or 5’ x 5’ rooms. The pattern you design can change every year or every night. The ScAir Chambers do not have any interior columns, except for the perimeter support columns. These units don’t even have a center support column, so you can utilize the interior any way you want.

Q: How will my props, or some of my pneumatic effects fit inside?

A: The 5’x5’ footprint will accommodate most props and pneumatic effects. There is also 10’ from the floor to the bottom of the horizontal tubes and another two feet to the ceiling. Pressure pads can also be placed underneath the floor

Q: How do I hang lighting and sound equipment?

A: There are nylon straps sewn to the bottom leading edge of all horizontal tubes, between every column. These straps will allow you to attach; lighting, sound and props. There are also “D” rings sewn into the vertical leading edges of all of the columns.

Q: How long does it take to go thru a ScAir Structure?

A: It all depends on you. Most people are surprised at how big ScAir Structures are inside. This is because the space is used very efficiently. Your design can lead patrons through in a hurry or keep them in for up to fifteen minutes.

Q: Since ScAir Structures are made of black material, does it get very hot inside?

A: Although the black material does absorb the heat, the air being released through the seams within the structure help cool the unit down considerably. You can also open all exits and ventilation hatches while working inside to increase ventilation.

Q: Is the material flame retardant?

A: YES! We provide the M.S.D.S.’s and label each unit with our certification.

Q: Can I get a ScAir Structure in a different color?

A: Of Course. We can build your structure in a variety of colors at no extra charge. We can also customize door locations and other aspects of your ScAir Structure.